HYPR Controllers Support
How to Reprogram Rear Mechanical ButtonsÂ
For Xbox / PS4 / PS5 Controllers with V1 Chip
Remap V1 - follow step 3 below to check. If Step 3 works, this is the remap version installed on your controller.
Remap V1 (For Xbox and PS4)Â
- To enter into remapping mode, hold D-PAD ARROW DOWN +Â ANY REAR BUTTONÂ for 5 seconds until a red LED illuminates below the home button (For Xbox, Home button will shine brighter).
- Once in remapping mode hold your desired face button + the back button you want to assign it to for about 5 seconds or until the LED turns off. Then you're done! Repeat for other back buttons.
- To reset remapping chip, HOLD O + X+ SQUARE + TRIANGLE then turn the controller back on by either pressing the PS button or plugging it in. The LED light will blink rapidly.
For more recent ordered PS5 / Xbox follow V3
Remap V3 (For PS5 and Xbox).Â
- To enter remapping mode, hold the Home button (Xbox: View Button) for 5 seconds until the LED on the left side of the touchpad glows green or purple (Red for Xbox).
- While in remapping mode, press and hold any face button and rear button/paddle that you want to bind together. The LED should blink to confirm the button mapping. Repeat this step for other buttons/paddles.
- To exit remapping mode, hold the Home button for 5 seconds until the LED turns off.
- To clear button mappings or disable the back buttons/paddles, press and hold the Home button. The LED will turn on. Keep holding it until you see the LED blink three times, and then let go to clear the back button bindings. Press and hold the Home button again to exit remapping mode.Â
Â
For more recently ordered PS4 (2025), please follow this remap instructions
Enter Programming Mode:
- Hold R1 + R2 + L1 + L2 simultaneously for 8 seconds.
- The LED will flash one long flash, indicating the controller has entered programming mode.
Configure Back Button for Remapping:
- Press and hold the back button you want to remap.
- While holding the back button, tap any button(s) you want to assign to it. Multiple buttons can be assigned.
Examples:
- Single Button: Hold the back button, tap Triangle, then release the back button. Now, pressing the back button will trigger Triangle.
- Multiple Buttons: Hold the back button, tap X, R1, and UP on the D-pad, then release the back button. Now, pressing the back button will activate all three inputs simultaneously.
Exit Programming Mode & Save:
- To save changes and exit, tap the touchpad on the controller.
- Your new button mappings are now active!
Master Reset (Restore Defaults):
- Turn off the controller.
- Hold X + Triangle + Circle + Square while turning the controller back on.
- The LED will flash rapidly 10 times, indicating a successful reset.
If you need any assistance, please email us at support@hyprcontrollers.com